- The power switch of the ML6 Connect can be individually programmed with switch profiles according to the user’s needs in terms of scope and composition of all available light functions and pre-defined intervals.
- The light functions of an individual switch profile can always be selected by using the power switch of the lamp.
- After programming and sending the individual switch profile for the power switch to the lamp, it is stored, as long as the switch profile is not changed/replaced by a new switch profile via app.
- The direct red light activation from off mode via “+” switch and “-“ switch always works, independently from any individual power switch programming and even if no red light function has been assigned to a stored switch profile.
- As a default switch profile, the following light functions will be preinstalled for first use, but can be changed afterwards: Continuous white light (mid power, dimmable), continuous red light (mid power, dimmable), white blink, red blink. No special function (double click) will be preinstalled. This default setting can always be restored by keep pushing the power switch of the ML6 Connect for 8 sec. or via app (select “Factory reset” in “Device Settings”).
- Help text in app:
- Profile help text in app for profile selection: “Program the witch of the lamp with individually created sequences of light functions. Up to eight switch profiles can be created, e.g. for different activities. To create a switch profile, tap on the switch profile slots. Tap and hold to send switch profile to lamp or for further options. Flashing red light indicates successful transmission to lamp.”
- Profile help text in app for profile creation: “A switch profile can be composed of up to six individually selected light functions. After sending the profile to the lamp, the light functions can be activated in the desired order by using the power switch of the lamp. Intervals that have been created and stored before can be assigned to single light functions. Special light functions such as Boost or Tactical Strobe can be assigned to each profile by using the Double Click function. 2 quick consecutive clicks on the switch of the lamp will activate the special function.”